![]() I went back upstairs, restarted my Mac in the 'dark side' mode (Windows 7- Bootcamp), downloaded the Logitech Harmony One software (7.7.0), and it opened and worked OK. So, I went down to my workshop older Mac laptop(running 7.7.0), and proceeded about my business, including writing a note to Logitech about my troubles[ IR/RF, AND the software not loading). ![]() When I installed it, I got the same blank window, and have been unable to do anything about it. It occurred to me that I might need a software update so I downloaded 7.8.1 to replace the 7.7.0 I had been using on my almost brand-new IMac. Then the regular widow loaded, and I proceeded with my IR/RF problems. When I re-opened it, all that showed up was a blank window( after a (at the window's bottom) web-based update) which remained blank for about 10-15 minutes. However, after trying to update the Harmony remote with the supplied Comcast remote(unsuccessfully, because the remote was only putting out RF), I quit the program, which had opened very slowly(unusual). This software has always worked well and faithfully. In the process, I updated my Harmony One, and in THAT process, I opened and tried to update the remotes with my computer's Logitech software. There were several problems, centered upon when the supplied remotes were using RF, versus IR(which is required by the Harmony One). A few days ago, I had to update my home entertainment system with two new HD Comcast set-top boxes, which use IR/RF signals to change channels and decode the newly encrypted basic service.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |